AES 7170 Instrukcja Użytkownika Pobierz pdf (Strona 72)

40-7705I-UM Page 72 Rev 4 March 16, 2007

Explanation of the Control Group Functions:

Function Explanation

TURN ON TX

• Press <ALT> + <C>

• Press <1>

• Select Target Unit

• Select Route

• Re-enables transmitting on a remote subscriber unit that

has been turned off (see Turn Off TX, next).

TURN OFF TX

• Press <ALT> + <C>

• Press <2>

• Select Target Unit

• Select Route

• Disables a remote subscriber unit should the need arise,

such as when an alarm system fails and causes the

transmitter to activate repeatedly. NOTE: The unit is not

literally turned off, but is prevented from transmitting until

it receives the "Turn On" signal (above). Also Note that a

transceiver in the Off Mode will create route failed

message when including in an outbound route.

• A reset will clear this mode and return to TX ON.

WARNING: This function disables the subscriber - use it

only when absolutely necessary.

• This function may be used on UL Burglar Alarm and Fire

Alarm systems only with strict adherence to the

requirements of UL Standard 611, Central Station Burglar

Alarm Units and the National Fire Alarm Code, NFPA 72.

REMOTE RESET

• Press <ALT> + <C>

• Press <3>

• Select Target Unit

• Select Route

• Resets the remote subscriber unit - the same as physically

pushing the reset button on the unit itself. This causes the

subscriber unit to re-enroll on the network and build a new

routing table. A reset may be used to restart the check-in

interval timer. The new interval will commence at the time

of reset (see also: subscriber unit manuals).

INTELLITAP

MESSAGES

• Press <ALT> + <C>

• Press <4>

• Select Target Unit

• Select Route

• Enter D to Disable, E to Enable Tap

Messages

• Enables / Disables the subscriber unit's ability to send

IntelliTap Messages. CAUTION: Once disabled, the

subscriber will ignore IntelliTap or FDX data presented to

its port.

• This function works with 7750-F, 7050-E (Ver 2+), 7450

and 7440 models.

• To confirm the function, perform a "Get Subscriber Mode

Data" to retrieve the current status of this mode (Message

group, # 9) and to update the database.

• Refer to subscriber unit and IntelliTap manuals for more

information.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 110 111

Komentarze do niniejszej Instrukcji

Brak uwag

AES 7170 Instrukcja Użytkownika Strona 72

Komentarze do niniejszej Instrukcji