AES 7170 Instrukcja Użytkownika Pobierz pdf (Strona 106)

40-7705I-UM Page 106 Rev 4 March 16, 2007

Radionics 6500 compatible output format:

This mode will provide the output of 3 line cards; line card 1 is for AES subscriber and

receiver signals, line card 3 is for Contact ID signals from IntelliTap, and line card 4 is for

4+2 signals from IntelliTap.

Contact ID signals are translated into an AES’ Radionics message as outlined under line

card # 3 and 4 elsewhere in this appendix. Due to this translation it is preferred that the

Ademco emulation be used when IntelliTap or other contact ID message producing

interfaces are used.

Line Card # 1 AES signals from subscribers and receivers.

Signal format: 1RRLssssssACCTEEsNNNs<0x14>

Key to codes used in signal format above:

1 = 1 is for automation signal. (a 3 indicates text data)

RR = Receiver number, user programmable. Between 01 and FF.

L = Line card number, Line card is selected by firmware or software. 1 - 4

ACCT = Four digit subscriber ID or 4 blank spaces for AES receiver

EE = Event code (See event codes below)

NNN = Zone, status or fault code *

s = <Blank space>

<0x14> = Termination character

* Note: The value of NNN or (N2N1N0) in Radionics 6500 format, (or N2 N1 N0 as

used for this example) is computed as follows: Value = N2 X 16 + (N1 X 10 +

N0). The numbers in positions N1 and N0 represent the two digit decimal

equivalent of a single digit hexadecimal number. It will never be greater than

decimal 15. The number in position N2 represent the decimal equivalent of a

Hexadecimal number where 1 = decimal 16 and 2 = decimal 32.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111

Brak uwag

AES 7170 Instrukcja Użytkownika Strona 106